al tec_on_drum te All This state parameter is used to keep track of where the trailing edge clamps are. If this parameter is set to 1, the firmware thinks the clamps are on the drum. This parameter is used by the firmware for internal 'housekeeping'. It is not normally modified with the 'set' command. integer
  • 0
    •
  • 0 to 255
    •      state
  • ..\..\ShowAllErrors.htmFirmware 0 Error Index
  • ..\..\ShowAllCommands.htmFirmware 0 Command Index
  • ..\..\ShowAllNVS.htmFirmware 0 NVS Index
    •  Updated: Wed Jul 16 19:36:05 2008 PST